Account

What new tool do you want?

Science & Engineering

3D Print Cost Calculator

Estimate the cost of a 3D print from filament used, filament price, print time, printer power and machine wear — plus a selling price with markup.

How to use

  1. 1Enter the filament used (grams, from your slicer) and the spool price.
  2. 2Enter the print time, printer wattage, electricity price and optional wear cost and markup.

How it's calculated

Cost = grams × price per kg ÷ 1000 + hours × watts ÷ 1000 × price per kWh + hours × wear per hour. Price = cost × (1 + markup).

Frequently asked questions

Where do I get the filament weight?

Your slicer (Cura, PrusaSlicer, Bambu Studio) shows the estimated grams and print time after slicing.

What should wear cost include?

Printer depreciation plus parts like nozzles, belts and build plates — often $0.10–0.50 per hour for hobby printers.

How do I price prints for sale?

Add failed-print allowance, your time for setup and post-processing, then a markup for profit.

Why filament, not electricity, usually dominates the cost

A typical hobby 3D printer draws only 100–200 W — comparable to a couple of incandescent light bulbs — so even a long print accumulates a relatively small electricity bill, while filament is priced per kilogram and even a modest print can use a meaningful fraction of a spool. That's why, in the worked example below, filament cost is more than 17 times the electricity cost for the same print — a ratio that holds for most desktop FDM prints unless local electricity is unusually expensive or the filament unusually cheap.

Worked example: 3D Print Cost Calculator

120 g of filament from a $22/kg spool costs 120 × 22 ÷ 1000 = $2.64. A 6-hour print on a 150 W printer at $0.17/kWh uses (6 × 150 ÷ 1000) × 0.17 = 0.9 kWh × $0.17 ≈ $0.153 in electricity. Adding $0.20/hour of wear for 6 hours adds $1.20, for a total cost of 2.64 + 0.153 + 1.20 = $3.993. A 50% markup brings the sale price to $3.993 × 1.5 ≈ $5.99.

What this total still leaves out

This cost model assumes the print succeeds on the first try — it doesn't build in an allowance for failed prints, which happen often enough in practice (adhesion failures, clogs, power interruptions) that sellers typically price in a failure-rate buffer on top of the direct material and machine cost. It also doesn't count the time spent designing, slicing, bed leveling, supervising, or post-processing (removing supports, sanding, painting) — all real costs for anyone selling prints rather than making one for themselves.

Blank wear or markup means zero, and the currency is only a label

The defaults are 120 grams, 22 per kilogram, 6 hours, 150 watts, 0.17 per kilowatt-hour, 0.20 of wear per hour, and a 50 percent markup. Filament is grams times the spool price divided by 1,000. Electricity is hours times watts divided by 1,000, times the kilowatt-hour price. Wear is hours times the hourly rate. If I clear wear, or markup, the blank counts as zero rather than breaking the total, so a personal print with no shop rate and no margin is just filament plus power. Markup is applied to the whole cost, including electricity and wear, not to filament alone. The currency menu, US dollars through Australian dollars, labels the money figures. It does not convert a spool price I entered in one currency into another.

Related tools

More: Science & Engineering