Account

What new tool do you want?

Science & Engineering

Resistor Color Code Calculator

Decode 4, 5 and 6-band resistor color codes into resistance, tolerance and temperature coefficient — or find the bands for a value.

How to use

  1. 1Choose the number of bands.
  2. 2Pick each band's color from left to right (the tolerance band is usually spaced apart).

How it's calculated

4-band: two digits × multiplier, tolerance. 5-band: three digits × multiplier, tolerance. 6-band adds the temperature coefficient.

Frequently asked questions

Which end do I read from?

Start from the end with bands closer together; gold or silver tolerance bands are always on the right.

What's a memory aid for the colors?

Black, Brown, Red, Orange, Yellow, Green, Blue, Violet, Grey, White = 0 to 9.

What does tolerance mean?

How far the real value may be from the marked value — a 1 kΩ ±5% resistor measures between 950 and 1,050 Ω.

A worked example: brown-black-red-gold

Brown and black are the first two digits (1 and 0, since black = 0), giving the significant digits '10'. Red is the multiplier band, worth ×100. So the value is 10 × 100 = 1,000 Ω, and gold means ±5% tolerance — a 1 kΩ ±5% resistor, exactly the tool's first built-in example, with a true value guaranteed to fall between 950 and 1,050 Ω. A 5-band version with the same first two digits plus a third black digit and a brown (×10) multiplier reads 100 × 10 = 1,000 Ω at a tighter ±1% (brown tolerance band) — the extra digit band is what lets 5-band resistors express three significant figures instead of two.

Why 5 and 6-band resistors exist at all

A 4-band resistor can only express two significant digits, which is plenty for a 5% part but not precise enough to be meaningfully correct to 1% — a 1% resistor needs a third significant digit to actually mean something, which is why 1%-and-tighter parts almost always use 5 or 6 bands. The 6th band, when present, adds a temperature coefficient in parts-per-million per kelvin — the code's table runs from 250 ppm/K (black) down to 1 ppm/K (grey), meaning a precision-grade resistor's value drifts far less per degree of temperature change than a standard one, which matters in calibration equipment and precision voltage references but is irrelevant for a pull-up resistor on a hobby board.

Reading direction and the two special multiplier colors

You read from the end where the bands are spaced closer together, because the tolerance band (gold or silver) is always set apart on the right — if you can't tell which end is which, find the gold or silver band first and read backward from it. Gold and silver also moonlight as multipliers worth ×0.1 and ×0.01 respectively, which is how resistors below 10 Ω (like 0.1 Ω or 2.2 Ω) are coded without needing a dedicated 'decimal point' band.

The range line is the tolerance turned into ohms

Four bands is the starting point: brown, black, red, gold, which is 1 kilohm plus or minus 5 percent, and the range line spells out the low and high ends, 950 ohms to 1,050 ohms. The tolerance band is a separate selector, including none for plus or minus 20 percent. Gold and silver as multipliers mean times 0.1 and times 0.01, which is how a value under 10 ohms gets a code. Band 3, the extra digit, is hidden on four-band parts and shown for five and six. The temperature-coefficient selector appears only for six bands, and only then does that ppm-per-kelvin line show up in the results.

Related tools

More: Science & Engineering