Account

What new tool do you want?

Science & Engineering

Air Conditioner Size (BTU) & Heating Calculator

Find the right air conditioner size in BTU for a room using the ENERGY STAR chart, with adjustments for sun, occupants and kitchens — plus a heating BTU estimate by climate.

How to use

  1. 1Enter the room size in square feet (or metres).
  2. 2Adjust for shade or sun, the number of people and whether it's a kitchen; choose your climate for heating.

How it's calculated

Cooling: ENERGY STAR room-size chart; −10% if heavily shaded, +10% if very sunny, +600 BTU per person beyond two, +4,000 BTU for kitchens. Heating: area × BTU per sq ft by climate (≈ 30 in hot to 60 in cold climates).

Frequently asked questions

Why not just buy a bigger AC?

An oversized unit cools quickly but switches off before removing humidity, leaving the room cold and clammy and wasting energy.

How do BTU and tons relate?

One ton of cooling = 12,000 BTU per hour.

Is this a replacement for a Manual J calculation?

No — whole-house HVAC systems should be sized by a professional with a Manual J load calculation.

Sources

A worked example: the same room, two very different numbers

A 350 sq ft room with normal sun exposure and two occupants lands on the ENERGY STAR chart's 8,000 BTU/h bracket. Take that same room, add sun exposure and two more people, and make it a kitchen, and the number jumps to 14,000 BTU/h: the base 8,000 is multiplied by 1.1 for strong sun (8,800), then 600 BTU is added per extra occupant beyond two (2 people × 600 = 1,200, bringing it to 10,000), then 4,000 BTU is added flat for a kitchen's cooking heat load, landing at 14,000. That's a 75% increase from the same floor area, entirely from factors the square-footage chart alone doesn't capture.

Why oversizing backfires

An air conditioner's main dehumidifying action happens while it's running continuously, pulling moisture out of the air as it cools. A unit sized too large for the room cools the air to the thermostat setpoint and shuts off quickly, before it's had enough runtime to also remove much humidity — leaving the room cold but still damp, often described as 'clammy.' It also cycles on and off more often, which uses more electricity and wears the compressor faster than a correctly sized unit running longer, steadier cycles.

Why heating uses a flat rate per square foot instead

The heating estimate here (area × a BTU-per-square-foot figure that ranges from about 30 in hot climates to 55+ in cold ones) is a much rougher rule of thumb than the cooling chart, because heating load depends heavily on insulation quality, window count and local design temperature — factors a whole-house Manual J calculation accounts for explicitly. The climate-zone multiplier is meant for a ballpark figure, not a substitute for that kind of professional load calculation before buying a furnace or heat pump.

Past 2,500 square feet the chart is left behind

A room of 350 square feet, normal sun, two people, not a kitchen, is 8,000 BTU per hour on the chart, and the heating line uses the climate rate times the area, 45 times 350 in the default cool zone. Sun, extra people, and the kitchen add-on apply only to cooling. People are rounded, and only the count above two adds 600 BTU each. Shade multiplies the chart value by 0.9 and full sun by 1.1 before those flat adds. A kitchen adds 4,000 only when that switch is on. Above 2,500 square feet the chart is replaced by 14 BTU per square foot. Square metres are converted with a factor of 10.7639, and anything under about 50 square feet is refused.

Related tools

More: Science & Engineering