Account

What new tool do you want?

Home & DIY

Roof Snow Load Calculator

Estimate the weight of snow on a roof from depth and snow type — pounds per square foot and total load — and compare it with the roof's design load.

How to use

  1. 1Enter the snow depth and choose the snow type.
  2. 2Enter the roof area and design snow load (from local building code) to compare.

How it's calculated

Load (psf) = depth (ft) × density: fresh snow ≈ 7 lb/ft³, settled ≈ 15, packed/wet ≈ 20, ice ≈ 57.

Frequently asked questions

How much snow can a roof hold?

Depends on design: many US homes are designed for 20–30 psf, more in snowy regions. Check local code or your plans.

Why does snow type matter so much?

A foot of wet, packed snow can weigh three times as much as a foot of fresh powder.

When should I remove snow?

If loads approach the design value or you see sagging, cracking or doors that stick. Use a roof rake from the ground — don't climb on a snowy roof.

Why snow depth alone tells you almost nothing about roof risk

Two feet of snow can mean a load anywhere from 14 lb/ft² to over 100 lb/ft², depending entirely on whether it's dry fresh powder, settled older snow, or wet packed snow that's been rained on and refrozen — the density multiplier matters more than the depth number people tend to watch and worry about. This is why the calculator forces a snow-type selection rather than estimating purely from inches: a homeowner mentally tracking 'how many inches fell' without accounting for density can badly misjudge actual roof load, especially as a snowpack ages and compacts or absorbs rain.

Worked example: Roof Snow Load Calculator

24 inches of settled snow (15 lb/ft³ density) works out to (24÷12) × 15 = 30 lb/ft² of load. Across a 1,500 ft² roof, that's 30 × 1,500 = 45,000 lb total — over 22 tons sitting on the structure. Compared against a design load of 30 psf, this load sits at exactly 100% of what the roof was engineered to carry, which the calculator flags directly as the share of design load used up.

Why the same snow event can mean very different things to different roofs

The same 24 inches of snowfall that uses up 100% of a 30 psf design roof's capacity would only use up 60% of a 50 psf design roof common in heavier snow regions — design load varies substantially by local building code and climate, which is why entering your own roof's actual design value (from your building plans or local code) matters far more than assuming a generic number. A roof built decades ago to older code may also carry a lower design load than current standards require for the same region.

What this estimate can't tell you about your actual roof

This calculates load from idealized density figures for a snow type you select — it can't account for drifting (wind piling snow unevenly, concentrating load on one section well beyond the average), ice dams at eaves, or a roof's actual structural condition, which may have degraded from the condition it was originally designed for. Visible sagging, cracking, or doors and windows that newly stick under snow load are warning signs this number-based estimate can't substitute for — and removing snow safely means a roof rake from the ground, not climbing onto a loaded roof.

Related tools

More: Home & DIY