Account

What new tool do you want?

Home & DIY

Roofing Calculator (Squares & Shingles)

Calculate roof area from the house footprint and roof pitch, then the roofing squares, shingle bundles, underlayment rolls and cost.

How to use

  1. 1Enter the building footprint (length × width, including overhangs) and the roof pitch (rise per 12 in of run).
  2. 2Add waste — more for complex roofs with valleys and hips.

How it's calculated

Pitch factor = √(1 + (rise ÷ 12)²). Roof area = footprint × pitch factor. Squares = area ÷ 100 × (1 + waste). Three-tab and architectural shingles: 3 bundles per square.

Frequently asked questions

What is a roofing square?

100 square feet of roof surface.

How much waste should I add?

About 10% for simple gable roofs and 15–20% for hip roofs or roofs with dormers and valleys.

How do I measure pitch?

Hold a level horizontally against the roof, measure 12 in along it, then measure vertically to the roof surface — that's the rise.

Why pitch matters more than most people expect

A footprint measurement alone understates roof area, because a sloped surface covers more actual square footage than the flat ground beneath it — the steeper the pitch, the bigger that gap gets. The pitch factor (√(1 + (rise/12)²)) captures this: a 6-in-12 pitch gives a factor of about 1.118, meaning the real roof surface is roughly 12% larger than the footprint, while a steeper 9-in-12 roof pushes the factor to about 1.25, a 25% increase over the same footprint. Skipping the pitch adjustment and just using footprint square footage is one of the most common ways people underestimate materials for a non-flat roof.

Worked example: Roofing Calculator

A 50×30 ft footprint with a 6-in-12 pitch gives a roof area of 50 × 30 × 1.118 ≈ 1,677 ft² — noticeably more than the 1,500 ft² footprint alone. Adding 10% waste and dividing by 100 gives about 18.4 roofing squares, which at 3 bundles per square rounds up to 56 bundles of shingles. The same pitch converts to an 26.6° roof angle (arctangent of 6/12), a figure worth knowing separately from the pitch ratio since some contractors and safety guidelines reference angle rather than rise-per-12.

Why waste allowance should track roof complexity, not just size

A simple gable roof with two flat slopes wastes relatively little material since shingles just run in straight courses, which is why 10% is the usual rule of thumb. A hip roof, or one with dormers, valleys and multiple ridgelines, forces far more angled cuts, and offcuts from one valley usually can't be reused elsewhere — which is why those roofs commonly need 15-20% waste instead. Underestimating waste on a complex roof is a common way to come up short on bundles partway through the job, when matching the exact shingle batch may no longer be possible.

Bundles assume three per square, and the price rounds the squares up first

The roof area is the footprint times a pitch factor, and squares are that area plus waste, divided by one hundred. Bundles are three times the squares, rounded up, which is the usual three-bundle square and not something I can change. Underlayment rolls assume four hundred square feet each and also round up, using the area with waste. The angle is shown in degrees from the same rise-per-twelve pitch, which opens at 6. If I enter a price per square, the cost uses squares rounded up to a whole square, not the decimal squares in the main line, so the bill can sit a little above squares times price. Waste opens at 10 percent.

Related tools

More: Home & DIY